Brass rod

Volyn' Biznes Resurs offers square, round, hexagonal and rectangular brass rods.

---

 

CuZn37 (European analogue of L63 alloy) - copper content - 63%, zinc - 37%. 

CuZn39Pb2 (European analogue of LS59 alloy) - lead brass, copper content - 59%, zinc - 39%, lead - 2%. 

---

 

The product is manufactured in accordance with the European standard:

EN 12163 "Copper and copper alloys - Rod for general purposes" 

EN 12164 "Copper and copper alloys - Rod for free machining purposes"

 

---

 

VBR offers brass rod in soft, half-hard and hard state according to EN 12163 and EN12164. Each state provides certain characteristics for rods: hardness, tensile strength and elongation.

Hardness - is the value of material hardness. The measurement is carried out according to the Vickers method: determining the hardness of the metal by the size of the impression left by a diamond tip in the form of a quadrangular pyramid, which is pressed into the surface under the influence of the load. It is defined in units of HV.

Tensile strength - that is, temporary resistance - a measurement of the load corresponding to the greatest effort that precedes the destruction of the sample. It is measured in N/mm² (MPa).

Elongation - that is, relative elongation - is a value that shows the percentage by which a material is elongated before it breaks. This indicator is especially important for sheets used for deep drawing. It is measured in %.

---

 

According to EN 12163, EN 12164 offers brass rods of alloys CuZn39Pb2 and CuZn37 with the following characteristics:

Elongation

Tensile strength

Hardness