Bronze rod

Volyn' Biznes Resurs offers bronze bar in stock and to order.

---

 

The CuAl10Fe3Mn2 alloy is a European analogue of the CuAl10Fe3Mn1,5 alloy, it is produced by the method of hot pressing and has anti-friction characteristics.

The CuSn5Zn5Pb5 alloy is a European analogue of the BrО5Ц5С5 alloy, produced by the casting method.

The CuCr1Zr alloy is a European analogue of the BrX1Cr alloy.

 

---

 

The product is manufactured in accordance with the following European standards: EN 12163, EN 12165 and EN12167.

---

 

VBR offers copper rod in soft, half-hard and hard state according to EN 12163, EN 12165 and EN 12167. Each state provides certain characteristics for rods: hardness, tensile strength and elongation.

Hardness - is the value of material hardness. The measurement is carried out according to the Vickers method: determining the hardness of the metal by the size of the impression left by a diamond tip in the form of a quadrangular pyramid, which is pressed into the surface under the influence of the load. It is defined in units of HV.

Tensile strength - that is, temporary resistance - a measurement of the load corresponding to the greatest effort that precedes the destruction of the sample. It is measured in N/mm² (MPa).

Elongation - that is, relative elongation - is a value that shows the percentage by which a material is elongated before it breaks. This indicator is especially important for sheets used for deep drawing. It is measured in %.

 

---

 

According to EN 12163, EN 12165 and EN 12167 offers bronze rods of alloys CuAL10Fe3Mn2, CuSn5Zn5Pb5 and CuCrZr with the following characteristics:

Elongation

Tensile strength

Hardness